MRI Caddy
Click image to enlarge

The MRI Caddy®; allows drug dependent patients to be examined in the MRI Room, and guarantees optimum drug administration during all phases of investigation from preparation, through scanning to post care. The ability to ensure continuous and permanent drug administration decreases examination time to a minimum. The MRI Caddy® meets all Anaesthetists requirements.

This unit can use syringes of all sizes from 1ml to 60ml made by the following manufacturers: Becton-Dickinson, Monoject, Terumo, Becton-Dickinson Glass, Abbott, Braun, Fresenius and Perfusor. For ease of use it can be field customised for a single manufacturer`s syringes.

Other key features include:

Features
Infusion Modes Body Weight, Mass Modes, Continuous and Volume/Time. (Can be field customised)
Flow Rates 0.01 to 378.0 ml/hr dependent on syringe size.
Bolus In Body Weight, Mass and Continuous Modes.
Alarms/Alerts Near Empty, Empty, Dose Vol. Delivered, Bolus Delivery, Occlusion, System Malfunction, Low Battery, Depleted Battery, Syringe Pops Out, Invalid Size, Invalid Number, Check Clutch.
Technical Specification
Accuracy +/- 2%
Flow Rate 0.01 ml/h to 400 ml/h depending on syringe size selected
MR Type 0.2 to 1.5 Tesla
Operating Voltage 110/230 volt 50/60 Hz
Battery 7.2v / 1.3 Ah per pump
Typical Duration approx 7 hours
Power Consumption 110 VA
Environmental +5 through 40° C
Operating Temperature 40 through 105° F
Humidity 30% through 90%
Dimensions
Height 135cm (increases to 180cms when IV Pole extended)
Width 61cm
Depth 48cm
Weight 35kg
Syringe Sizes (3 component syringes)
B-D Becton Dickinson 1, 3, 5, 10, 20, 30, 60 ml
BBM Braun 2, 5, 10, 20, 30, 60 ml
PERF Perfuso 50 ml
TERU Terumo 1, 3, 5, 10, 20, 30, 60 ml
FRES Fresnius 10, 50 ml
BDG Becton Dickinson Glass 1, 3, 5, 10, 50 ml
Abot Abbott 50 ml
MONO Monoject 1, 3, 6, 12, 20, 35, 60 ml
Ref: MR8000 MRI Caddy® MR Conditional

To guarantee warranty and MR safety only trained personnel should undertake any maintenance on these products.